COM-HPC Carrier Layout

M

michaelvanover

On front view, the Compute Module is correctly labled as 90mm X 100mm however it is not shown in the proper size on the front. the compute module should be shown with the correct proportions. It needs to take up more space. Redo and show front view

flux

I’ll update Version 5.0 front-view visuals only so the Compute Module is drawn with correct 90 mm × 100 mm proportions and occupies the appropriate larger area. Version 4.0 stays locked.
Worked for 3 mins 46 sec
Thought for 26 sec
Generated image.
M

michaelvanover

You can move the component labels off to the side of the PCB

flux

Redone for Tiny Tim Version 5.0 front view.
Changes applied:
  • Compute Module is shown much larger with intended 90 mm × 100 mm proportions.
  • Carrier board remains 105 mm × 115 mm.
  • Labels moved off the PCB as side callouts to reduce clutter.
  • Version 4.0 remains locked and unchanged.
Updated file:
Updated Front View

Tiny Tim Version 5.0 Front View

Redo rear and review
Lock Version 5.0
Compare front views
Check label accuracy
Improve compute module fit
Sign up to send

Files

Schematic

Layout

Preview

Current State Visuals: Tiny Tim Version 5.0
Status
Tiny Tim Version 5.0 is the forward branch from locked Version 4.0.
Version 5.0 front-view requirement change applied:
  • Compute Module must be shown with correct 90 mm x 100 mm proportions.
  • Compute Module should occupy most of the 105 mm x 115 mm carrier board area.
  • Component/connector labels may be moved off the PCB to side callouts to reduce clutter.
  • Version 4.0 remains locked and unchanged.
Front View Reference — Updated Version 5.0

Tiny Tim Version 5.0 Front View - Compute Module proportional with side callouts

Rear View Reference — Copied from Version 4.0

Tiny Tim Version 5.0 Rear View - copied from Version 4.0

  • Status

  • Front View Reference — Updated Version 5.0

  • Rear View Reference — Copied from Version 4.0