Temperature and Humidity Sensor Node Design
Thought
- Set Layout's sizeX to "25mm"
- Set Layout's sizeY to "25mm"
- Set Layout's boardShape to "rectangle"
- Set Layout's stackup to "Standard 4 Layer"
- Set Layout's boardInsetMargin to "0mm"
- Set Layout's keepOut to "0mm"
Task completed.
0:33
Search "what project-level properties currently exist in t...".
Getting a layout overview.
Getting a schematic overview.
Search project.
Thought for 2 sec
Work done
- Confirmed the project reset as a full wipe with nothing preserved.
- Removed all existing schematic content, including prior connectors, resistors, LEDs, seven-segment placeholders, net portals, and ground symbols.
- Cleared the active PCB contents so no prior footprints remain on the layout.
- Reset the layout to a neutral blank state with a minimal 25 mm x 25 mm rectangular board and default 4-layer stackup.
- Removed the old project metadata tied to the LED / seven-segment carrier concept and renamed the project to Blank Project Reset.
Success criteria review
- ✅ All schematic elements, connectivity, and annotations were removed.
- ✅ PCB layout is cleared of prior components and old routing content.
- ✅ Project properties were erased and the project is ready for new input.
Next steps
The project is now blank and ready to rebuild from scratch. Give me the new requirements, and I can start the new schematic and layout framework immediately.
Reset everything now
Keep board outline only
Start fresh requirements
