3D Model Alignment


I confirmed that all four shield pads are numbered 6, but only one renders—three are missing; simply assigning new numbers would leave them without matching terminals. I made no changes and filed an internal quality ticket for Flux team review.
May I add three matching shield terminals and give the four shield pads unique numbers, preserving their geometry, the five signal pins, and the 3D alignment?
yes, add 3 terminals
I’ll add three shield terminals and map them to the missing pads, then verify that all four shield pads render without changing their geometry or the 3D alignment.
Sent message to Repairing MICRO 4P DIP Shield Pad Mapping
"Repairing MICRO 4P DIP Shield Pad Mapping" completed.
The three terminals are added, and all four shield pads now render. I’m checking the final pin mappings and confirming that the signal pads, footprint geometry, and Model transform stayed unchanged.
Finished execution
"USB Shield Pad Repair Verification" completed.
Added EH2/7, EH3/8, and EH4/9 and updated the footprint mappings—all four shield pads now render, giving 9 electrical pads plus 2 locator holes. Verified that the five signal mappings, footprint geometry, and 3D model alignment remain unchanged.
Changes are saved but not published.

Pin #
Name
Type
Section
Pin Group
Orientation
Order
Sub-symbol
Terminal Type
1
VCC
Unspecified
Top
INPUT
2
D-
Unspecified
Right
INPUT
3
D+
Unspecified
Right
INPUT
4
ID
Unspecified
Left
INPUT
5
GND
Unspecified
Bottom
INPUT
6
EH
Unspecified
Bottom
unspecified
7
EH2
Passive
Bottom
8
EH3
Passive
Bottom
9
EH4
Passive
Bottom

MICRO 4P DIP