I’ll align the connector’s 3D model with the footprint pads and mounting holes, adjusting its position and rotation as needed. This requires Agent mode to edit the model placement and verify the alignment in 3D.

I’ll check the model against the footprint’s contact pads and mounting features, adjust its placement, then verify the fit in 3D.

Aligned the 3D model by setting Position to (0, −1.385, +0.100) mm, with rotation and scale unchanged. Verified all 16 contacts fit their pads, the locating pegs and shell tabs align with the mounting holes and slots, and the contact undersides sit at the footprint’s seating plane; footprint geometry was unchanged.