Verify C&K Part Number and Footprint


You’re right to challenge that—your drawing shows 0.190″ (4.83 mm) between columns and 0.185″ (4.70 mm) pin pitch, matching the current footprint’s spacing; my earlier blanket mismatch claim was too strong.
However, that drawing explicitly shows 7201SYZQE, with Z solder-lug terminals, whereas 7201P3DABE specifies A right-angle PCB terminals. So the MPN is valid, but this drawing does not confirm that the footprint is correct for it.
this then?

image

Yes—this is the correct “A: right-angle, PC through-hole” termination drawing for 7201P3DABE. The example uses a different actuator/bushing, but the termination style is the relevant one.
It shows bent PCB pins plus mounting supports, so the current six-slot footprint should not be approved for this part as-is; it needs checking against the corresponding PC mounting layout, not the section A–A view alone.
Okay, find the correct footprint and 3D model for this component.
I’ll look for footprint and 3D CAD files for the exact 7201P3DABE variant, then check any candidates against C&K’s drawings before recommending them.
I found a right-angle footprint candidate in the 7201MD9ABE library part: its six signal pads and two support pads match the illustrated A-termination mounting pattern, but exact compatibility with 7201P3DABE remains unconfirmed.
I did not find a verified, downloadable 3D model for 7201P3DABE—the candidate’s model has a different actuator and bushing, so it is not an exact substitute. The safe next step is to validate/adapt that footprint and create the exact P3/D model from C&K’s drawings; I haven’t changed your part.

Pin #
Name
Type
Section
Pin Group
Orientation
Order
Sub-symbol
Terminal Type
1
1
Unspecified
Left
1
unspecified
2
2
Unspecified
Top
3
unspecified
3
3
Unspecified
Right
5
unspecified
4
4
Unspecified
Left
2
unspecified
5
5
Unspecified
Bottom
4
unspecified
6
6
Unspecified
Right
6
unspecified

7201P3DABE