20V 6A 19.5mΩ@4.5V,3A 1.5W 2 N-Channel SOT-23-6 MOSFETs ROHS #CommonPartsLibrary #IntegratedCircuit #PowerManagement

Haptic Glove Controller Board NUCLEO-F411RE based Fixed Servo Connections to match standard servo wiring Revised footprint of 2n3904s transistors since base and emitter footprint were swapped Larger power traces Swapped SDO and SDI of SPI Lines to the FPC connector so it matches with peripheral.

IMU board used for finger-tracking in haptic gloves Difference from TinyIMU 4.0.2 is that there is an attempt to optimize board size

Haptic Glove Controller Board NUCLEO-F411RE based Fixed Servo Connections to match standard servo wiring Revised footprint of 2n3904s transistors since base and emitter footprint were swapped Larger power traces Swapped SDO and SDI of SPI Lines to the FPC connector so it matches with peripheral.

Haptic Glove Controller Board NUCLEO-F411RE based Fixed Servo Connections to match standard servo wiring Revised footprint of 2n3904s transistors since base and emitter footprint were swapped Larger power traces Swapped SDO and SDI of SPI Lines to the FPC connector so it matches with peripheral.

N-Channel 20 V 1.4A (Ta) 500mW (Ta) Surface Mount PG-SOT323

Full Wave Rectifier using Diodes

Welcome to your new project. Imagine what you can build here.

Welcome to your new project. Imagine what you can build here.

Electronic Design project utilizing co-pilot as a design assistance and Flux navigator.

Mini Project for breaking out USB-C for use with motors, mpus, power delivery.

A solder jumper is simply a pair of pads on a PCB trace that can be easily bridged with a solder ball.