Schematic Review Assistance
Thought for 2 mins 13 sec
Short answer: finish routing, then lock parts.
Do this next
-
Route: Run Auto-Layout to clear remaining airwires, then manually tidy critical nets:
-
Re-run ERC/DRC and fix any flags (especially wrong-net decouplers and SWD access to U1:PA13/PA14/NRST).
-
Replace remaining generics with stocked 0402, X7R, 16 V parts (Digi-Key):
- 100 nF: use your existing C14 pattern for all 100 nF decouplers.
- 1 µF: reuse C11 where 1 µF is specified.
- 10 µF: reuse C16 for bulk on VSYS/VDD.
- 10 kΩ pulls: reuse your 10 k 0402 pattern (e.g., R3); convert any remaining “Generic Resistor” pull-ups/downs to this.
- RF L1: keep as 0402 inductor placeholder (DNI ok until tune) or use L1/L2 footprints for continuity.
- Replace any remaining “Generic Capacitor” on the RF π pads with 0402 C footprints (DNI) to allow tuning.
Want me to:
- Run Auto-Layout and then re-run ERC/DRC, and
- Batch-replace all remaining generics with the stocked parts above?
If yes, I’ll queue it and report the review results.
Auto-Layout start
ERC/DRC checks
Batch replace capacitors
Batch replace resistors
