Guitar pedal starter template based on project by Mark Wu. Includes schematic and PCB layout for basic DIY pedal hardware. This includes two 1/4" jacks (one for input and one for output), a 9V power supply (including LED), a 3PDT true bypass wiring setup, and an example potentiometer that can be copy/pasted throughout the circuit. The headers are meant to be unpopulated so that wires can be soldered to the pads. PCB design rules imported from the JLCPCB 2-layer stackup template. #template

This project is a reference design for an ESP32-WROOM-32E based device. It features USB-C for power and data transfer, onboard voltage regulation, and multiple peripheral connections. It also includes a CH340C for USB to serial conversion #referenceDesign #project #ESP32 #ESP32WROOM #RF #WIFI #MCU #referenceDesign #simple-embedded #espressif #template #reference-design

Raspberry Pi 2, 3, 4 or 400 Model B+ connector with RPi board outline and mounting holes. good for Raspberry Pi Shield projects. Insulation Height 0.335" (8.51mm) Compatible part number: PPPC202LFBN-RC #RaspberryPi #HAT #RPi #template #project

Teensymoog A re-creation of the minimoog using Teensy 4.0 by Pierre-Loup M. https://hackaday.io/project/170474-teensymoog

The Robo Project is a mobile robotic platform featuring a Particle Argon board, 4 motor-wheels controlled by L293D drivers, and an HC-SR04 ultrasonic sensor for obstacle detection. It's ideal for exploration, remote control, and robotics education. #project #robot #template #L293D #car