ESP32 Robotics Controller
Thought for 7 sec
I’ll retrieve the corrective U12 report and independently verify pad containment, antenna keepout, and routability. If that gate passes, I’ll resume the ordered power-first routing plan.
Thought for 16 mins 27 sec
The independent U12 gate is still working through the conflicting edge and pad-containment geometry. Routing remains paused until it produces a clean preflight result.
Thought for 1 min 39 sec
"U12 Placement Check" completed.
Thought for 7 sec
The U12 placement verification executor completed, but its final report could not be retrieved and reconciled before tool access ended.
This session:
- Reconciled the prior contradictory U12 reports.
- Confirmed the latest known live candidate was U12 at X −52.5 mm, Y 29.0 mm, Bottom, 180°.
- Launched an independent placement gate covering pad containment, antenna orientation, six-layer copper clearance, U12/JPORT1 overlap, and R11/IO17 routability.
- Kept general routing paused to avoid routing around an invalid RF-module placement.
Still unresolved until the completed report is retrieved:
- Whether every U12 pad is fully inside the board and routable.
- Whether the antenna region has valid copper clearance on all six layers.
- Whether the U12/JPORT1 overlap and R11/IO17 routing warnings are cleared.
- Power-first routing, USB verification, redundant-copper cleanup, final DRC, and the remaining ordered production checks.
Execution stopped because your ACUs ran out.
