Fixing Routed Trace Error

ionescus

ionescus

Am rotit J1 (CLM) cu 90 grade si l-am pus pe Bottom layer manual. Acum sterge toate traseele existente si re-ruteaza toate conexiunile corect cu J1 in noua pozitie. 3V3 cu 0.4mm pe Top, restul cu 0.25mm pe Top. Rezolva toate erorile DRC. Aplica direct modificarile.
62 days

flux

2:26

Resolving user request.

Addressing user actions.

Planning user changes.

Understanding user intents.

Accessing knowledge base.

Checking if I can make the changes for you.

Reading docs about How to delete all traces on a PCB in Flux, set preferred trace widths per net (3V3 = 0.4 mm, others = 0.25 mm), prioritize Top layer routing, and run Auto-Layout/autorouter to route all remaining airwires. Also how to run DRC and fix overlapping copper and floating copper violations..

Reading docs about Delete all traces on the PCB, then route all airwires using Top copper with specific widths per net. How to set preferred trace widths and run autorouting or Auto-Layout in Flux. How to run DRC and resolve airwires, overlapping copper, and floating copper..

Reading docs about How to route traces in Flux PCB editor: start a trace, add waypoints, finish traces, switch layers, and resolve airwires. Also how to run Design Rule Check (DRC) and view/clear airwire errors..

Executing user commands.

Asta spune documentația Flux despre rutare:
"How to Start a Trace
To begin creating a trace:
  1. Hover your cursor over the pad where you want to start routing.
  2. A small white dot will appear on the pad—this is the trace handle.
  3. Click the white dot to begin routing your trace.
  4. Move your cursor to define the path. Click to add waypoints, and double-click to finish the trace.
Note: you can press the letter "F" at any time to change the direction of the trace angle (elbow).
Placing vias
There are two main ways of adding vias:
  • While in routing mode, you can right-click to select the target layer. Flux will automatically place a via and continue routing in the new layer
  • With the "Layout" object selected, right-click and go to "Add"->"Via""
Source
Ștergere toate traseele
Setare lățime 3V3
Setare lățime restul neturilor
DRC și erori
62 days
Sign up to send

To get started, talk to Flux or create a New Document.

Documents

    Documents are markdown text files which describe project goals, capture details, or even simulation outputs.

    Assets

    Assets are files uploaded to this project which can be used in various ways.

    eps rpi conn thumbnail
    Eps Pi

    Properties

    Pricing & Availability

    Distributor

    Qty 1

    Arrow

    $0.01–$0.01

    Digi-Key

    $0.01–$0.10

    LCSC

    $10.96

    Mouser

    $0.32

    TME

    $0.02

    Verical

    $0.01–$35.07

    Controls