GreenThumbAi Smart Ear Tag Design
Thought for 21 sec
Remaining layout issues
What remains
Severity summary
Notable pattern in the current report
Bottom line
Table
| Check | Count | Status |
|---|---|---|
| Airwires | 89 | Error |
| Floating copper | 31 | Error |
| Overlapping copper | 109 | Error |
| Total across these three checks | 229 | Error |
Table
| Category | What it means |
|---|---|
| Overlapping copper | Copper objects are shorting or geometrically colliding |
| Airwires | Nets still have unrouted or broken connections |
| Floating copper | Some vias, traces, or copper islands are disconnected from any valid net |
Table
| Priority | Category | Why |
|---|---|---|
| 1 | Overlapping copper | Highest risk because it can create real shorts |
| 2 | Airwires | Board is still incomplete electrically |
| 3 | Floating copper | Usually cleanup after routing/short fixes |
Table
| Observation | Interpretation |
|---|---|
| A few pad IDs repeat many times | The worst issues are likely clustered around a small number of hotspot components / footprints rather than spread evenly across the whole board |
| Some route segments and vias also repeat | There are likely local routing tangles causing multiple cascading DRC failures |
The board still has major unresolved layout problems and is not ready for fabrication yet.
Recommended next move
Table
| Step | Action |
|---|---|
| 1 | Fix the worst overlapping copper hotspot first |
| 2 | Re-check airwires after the shorted area is cleaned up |
| 3 | Remove floating vias / orphan copper last |
If you want, I can next inspect the repeated hotspot objects and map them back to likely component regions.
Inspect hotspot regions
Focus on overlap errors
Check specific objects
Airwire hotspot mapping
To get started, talk to Flux or create a New Document.
