Designing a complete product in Flux is an iterative workflow where the electronics, PCB layout, firmware, and mechanical enclosure stay in one project and are refined together.
- PCB-first: Define requirements → design and verify the schematic → size, place, and route the PCB → build the enclosure around the finished board. This is best when electrical performance, connector placement, antenna clearance, or board cost drives the product.
- Enclosure-first: Define how the product is held, mounted, and used → establish the enclosure, controls, ports, and internal envelope → design the PCB to fit those mechanical constraints. This is best for wearables, handheld products, tightly packaged devices, and products with a strong industrial-design target.
In both workflows, Flux can help select parts, capture and review the circuit, lay out the board, create parametric enclosure geometry, check physical fit, prepare firmware and bring-up documentation, and generate manufacturing outputs. You move through explicit checkpoints rather than treating the PCB and enclosure as independent artifacts.
No project changes were made in this session. Execution stopped because your ACUs ran out.