It seems like there might be some information missing from your question. You've mentioned an anode, but you haven't specified which particular component or designator it belongs to.

However, your project consists of diodes (D1, D2, D3, D4, D5) and each diode has an anode. Since the rest of your circuit is already connected and you mentioned the "anode at the bottom," I will assume you're talking about diode D5's anode which is still free in your circuit.

If you want to connect the anode of D5 in context of your design, there are a few options:

Could you please specify what you want to do with D5's anode or correct any assumptions I've made if they're incorrect?

i want to connedt anode pin of diode 2 connect with ccw of the variable resistor without overlapint with other wire

Sure, connecting the anode of diode D2 (D2:ANODE) to the counter-clockwise (CCW) pin of the variable resistor (VR1:CCW) can certainly be made without overlapping the wires in the schematic.

Here are the steps you should follow in Flux:

In case you have difficulty avoiding overlap, consider using jumpers or bridges in your design. This will require you to provide the routing manually. Depending on your physical board design and constraints, you may or may not have this option.

Remember, overlapping wires in a schematic are not necessarily a problem from an electrical point of view, but they can make the schematic difficult to read. Hence, a good practice is to avoid them where possible.

Since I don't have access to a real-time database, I can't suggest specific updates or replacements. However, when looking for a replacement for the diode D2 (MPN: S1J-E3_61T) manufactured by Vishay, you should look for diodes with similar or better specifications. Here are those important specifications for D2:

While searching for a replacement, make sure the diode supports the operating conditions of your circuit. You can consider other manufacturers like ON Semiconductor, STMicroelectronics, and Fairchild who offer a wide array of diodes.

Remember to check on the availability and compare cost too. After you find an alternative, be sure to validate its footprint and pinout match with your existing layout or if changes to the layout are required.