Raspberry Pi 5 HAT Netlist Review
Thought for 10 sec
Yes. We can create it using public Raspberry Pi 5 40-pin header/HAT mechanical info plus datasheets for the MAX31855, ADS1115, ACS712, DRV8871, relay interface, and connectors.
Because this template project is view-only for you, the clean path is either:
- fork/clone the template into an editable project, or
- start a new project from scratch with the HAT outline, 40-pin header, and your uploaded netlist.
I would build it in this order: schematic from the uploaded netlist → datasheet-required passives/decoupling/protection → power budget for 3.3 V, 5 V, and 12 V paths → ERC cleanup → HAT PCB outline/placement → routing. Since the template includes PCIe nets, I’d only keep PCIe if you actually need it; otherwise the HAT can be simpler and avoid controlled-impedance PCIe routing.
Start here if you want a fresh editable design: Create Raspberry Pi 5 HAT Project
Create the HAT in a new editable project using that prompt.
Thought for 4 sec
I’ll set up the new-project creation link with the full HAT design prompt so you can open an editable Flux project directly.
Thought for 5 sec
I can’t create the project for you directly from this chat, but this link will open Flux’s new editable project flow with the full prompt pre-filled:
After it opens, Copilot should begin the editable design in that new project.
Add TVS protection
Add HAT EEPROM
Set HAT dimensions
Add test points
