Temperature and Humidity Sensor Node Design
Thought for 4 sec
I’m blocked from executing project changes right now because the session has no remaining execution credits, so I could not add components, consult datasheets, wire the schematic, or run review checks.
Current project state:
- Empty project
- 0 components
- 0 nets
- No schematic or PCB layout changes made yet
Recommended design plan when execution is available:
- MCU/radio: ultra-low-power Wi-Fi + BLE 5.x module, likely ESP32-C6 / ESP32-C3-class module depending on availability and power targets.
- Sensor: digital temperature/RH sensor over I²C, e.g. Sensirion SHT4x/SHTC3-class or equivalent consumer-grade sensor.
- Power input: USB-C receptacle configured as 5 V sink with CC pull-downs for default USB-C current advertisement.
- Protection: input fuse/eFuse or power-path protection with reverse-current blocking, OVP, UVLO, and OCP sized for 0.5–3 A-capable sources.
- Regulation: protected USB-C 5 V rail feeding a high-efficiency 3.3 V regulator sized from a full power budget.
- Support circuitry: decoupling for every IC, I²C pull-ups, boot/config resistors, programming/debug header, reset/user button if appropriate, status LED with low-current value.
- RF/layout: antenna keepout, controlled placement around the Wi-Fi/BLE module, solid ground return, short decoupling paths.
- Validation: datasheet-based schematic review, ERC cleanup, power-budget document, firmware pin map, and bring-up checklist before layout.
Nothing has been modified yet; the next step is to resume with component selection, datasheet review, schematic capture, and validation once execution credits are available.
List part options
Power budget
Schematic architecture
Find humidity sensors
Save requirements note
No schematic yet
Talk to Flux to get started.
