Footprint Verification Request
Thought for 22 sec
Below is the summary review of the updated pad dimensions versus your design goals:
Table
| Parameter | Target from Datasheet/Design Goals | Updated Value | Assessment |
|---|---|---|---|
| Pad Spacing | 3.00 mm (center-to-center) | Unchanged | The pad spacing remains aligned with the datasheet and design goals. |
| Pad Size X (Width) | Originally set greater (e.g., ~4.25 mm typical) but revised for denser design or specific routing needs | 2.5 mm | The updated width of 2.5 mm meets your directive; verify that this width still allows sufficient solder fillet and electrical connectivity based on manufacturing requirements. |
| Pad Size Y (Length) | As per previous (mechanical drawing) | Unchanged | No changes were made to the length; ensure it still satisfies the datasheet recommendations. |
Review Notes:
- The reduction of Size X to 2.5 mm appears to achieve a denser layout but should be double-checked for solderability and robustness in the footprint review.
- Ensure that the overall solder mask and silkscreen clearances remain acceptable with the new pad width.
If these parameters meet the intended design criteria and manufacturing guidelines, your updated pad dimensions are aligned with your design goals. Please let me know if additional adjustments are required.
Confirm the pad size adjustments in the PCB editor.
Thought for 11 sec
All selected pads now have their Size X property set to 2.5 mm in the PCB editor. This adjustment aligns with your design goals for pad dimensions. Please verify in your PCB editor if the change meets your layout requirements and let me know if any further modifications are needed.
Check Pad Dimensions
Verify Dimensions
Review Pad Changes
Welcome 👋
Flux accelerates your PCB design with AI.
Create your account to start using this component and bring your ideas to life.