Fixing Missing Routed Traces
Thought for 50 sec
This error means Flux sees pads on the same net that are not physically connected by routed copper. That is exactly what the Airwires check reports: missing routed traces between pads in a net
For your specific case:
- ADHESION_1
P1is on the Top layer - ADHESION_2
P1is also on the Top layer - Both
P1pads are assigned to the same net, +BAT_RAW - So the fix is to route copper between those two pads, or remove/change the net assignment if they were not meant to be connected
What to do:
- In PCB view, select the airwire for
+BAT_RAWbetween ADHESION_1 and ADHESION_2. - Route a trace on the Top layer from
P1toP1. - Recheck the review.
Important:
- Your layout has plenty of board space, so this looks like a straightforward missing route, not a congestion problem.
- The project currently has many Airwires errors, not just this one, so fixing these two pads may clear only one of many unrouted nets.
If
+BAT_RAW on those two pads was accidental, then the real fix is on the schematic side:- disconnect or rename that net so they are no longer both on
+BAT_RAW.
If you want, I can inspect whether ADHESION_1 and ADHESION_2 are supposed to be on
+BAT_RAW, and tell you whether to route them or change the net.Inspect net intent
Check other airwires
Review +BAT_RAW path
