PCB Design for Raspberry Pi Pico
I want to design a PCB which will mount Raspberry pi pico 2H. There will be an 18 pin FCC with 0.5mm pitch which will connect to following pins of Pico: 3.3V, 15, GND, 10, 11, 12, 14, 13, 9, 22, Not-Connected, 5, 7, 6, 8, Not-Connected, Not-Connected, Not-Connected. There is another 4 pin crow-tail connector which is connected to following pico pins: 3.3V, GND, 2, 3. These are all GPIO pin numbers of Pico. There will be 4 holes in the corner of the PCB for mounting.
Thought for 1 min 35 sec
Your goal is a carrier PCB for a Raspberry Pi Pico 2H with your exact connector pin mapping and 4 corner mounting holes.
- I’ve created the plan and it’s ready to execute.
- Because this current project isn’t editable, start it as a new project here:
- Create new project
Click the link, then click Start on the plan bar.
PICO WH. It's not PICO 2H
Thought for 53 sec
Your goal is now a carrier PCB for a Raspberry Pi Pico WH. I updated the plan accordingly; revising the plan when requirements change matches the project-modification workflow
- Plan is ready to execute.
- Start it here: Create new project
Click it, then click Start on the plan bar.
Add ESD protection
Specify connector orientation
Add pull resistors
To get started, talk to Flux or create a New Document.
Welcome 👋
Flux helps you build PCBs faster with an AI teammate!
Create your account to collaborate, stay updated, fork your own version, and get instant answers from our AI agent.