BMP180 Floating Pin Fix
Thought for 32 sec
I’m blocked because there are no available ACUs, so I can’t inspect the PCB or run AI auto-layout/routing tools right now.
What has been accomplished so far:
- In the previous attempt, the PCB was identified as still needing layout work.
- No new placement or routing changes were applied after ACUs became unavailable.
What remains:
- Inspect the latest PCB state.
- Decide whether placement, routing, or both are needed.
- Run auto-layout/auto-routing and verify DRC results.
Once ACUs are available again, re-run this request and I can execute it automatically.
Start Auto-Layout
Thought for 2 sec
I’m still blocked because there are no available ACUs, so I can’t inspect the PCB state or run auto-layout/routing tools.
What has been accomplished so far:
- Earlier, the PCB was found to still need layout work.
- No additional placement or routing changes have been applied since ACUs became unavailable.
What remains:
- Inspect the board for unplaced/misplaced parts and airwires.
- Determine whether placement, routing, or both are needed.
- Apply auto-layout/auto-routing and verify the result.
Please restore/add ACUs, then send this request again and I can proceed automatically.
Inspect J1 first
Check J1 placement
Run ERC/DRC later
Auto-place and route
