AI Assistance Request
Thought for 16 mins 7 sec
Created a thread
NF Enclosure Design
Completed
View Thread
flux
The enclosure build is still running; the board measurements and mechanical constraints are being resolved before the base and lid are committed. I’m continuing through model generation and fit verification now.
Thought for 4 mins 16 sec
Received notification from "NF Enclosure Design" that it finished — picking the work back up.
Thought for 8 sec
flux
The enclosure executor has finished. I’m reviewing its asset placement, fit checks, and documentation against the agreed M4/no-bottom-hardware requirements before closing the task.
Thought for 36 sec
flux
Created and placed a two-piece gray PETG enclosure with separate, toggleable Enclosure Base and Enclosure Lid models. It uses top-access M4 screws threading into plastic bosses, with no bottom bolts or exposed bottom fasteners.
3D Model
3D Model
- Enclosure Build instructions
Open items
- Physically trial-fit the J1 and SW2 openings before final printing.
- The modeled 3.2 mm M4 pilot bore should be tuned for the selected self-tapping screw and printer calibration.
Add cable cutout
Export enclosure files
Review print readiness
Add labeling
