DC-DC Converter Design Inquiry
A DCDC converter, in is 30V, out is 5V, i need 1A, chip is LM5146QRGYTQ1, a small sarter board
Thought for 3 sec
I can’t continue executing design changes because there are no available ACUs right now.
Current project state:
- New empty Flux project created: Yelping Purple T-800
- No components or nets have been added yet.
- Requested design: small starter board using LM5146QRGYTQ1 buck controller, 30 V input, 5 V output, 1 A load.
What remains to be done:
- Verify LM5146-Q1 datasheet requirements for 30 V → 5 V / 1 A operation.
- Select MOSFETs, inductor, input/output capacitors, compensation network, bootstrap parts, current sense, feedback divider, and protection components.
- Capture the schematic.
- Create a power budget/design note and bring-up plan.
- Lay out the PCB with short high-current loops and proper thermal/current paths.
- Run ERC/DRC review before fabrication.
Once ACUs are available, I can build the schematic and starter PCB around the LM5146QRGYTQ1.
Find key parts
Calculate values
Save requirements
Check datasheet
No schematic yet
Talk to Flux to get started.
