ESP32-S3 PCB Expansion Design

flux

I can’t modify the project right now because execution credits are unavailable.
Current project state:
  • No components have been added.
  • No nets or schematic wiring exist yet.
  • The ESP32-S3 expansion board has not been created.
What remains to be done once execution is available:
  1. Add an ESP32-S3 Dev Board header/module footprint matching your specific dev board.
  2. Add two JST-XH 2.54 mm connectors, likely 2-pin each.
  3. Wire each connector to:
    • Pin 1: GND
    • Pin 2: a selected ESP32-S3 GPIO digital pin
  4. Add labels/net names for clarity, e.g. CONN1_SIG, CONN2_SIG, GND.
  5. Verify the GPIO choices are safe boot/non-strapping pins for the ESP32-S3.
  6. Run schematic review/ERC.
  7. After schematic approval, place the board and route the PCB.
Recommended default GPIOs, unless you prefer others:
  • Connector 1 signal: GPIO4
  • Connector 2 signal: GPIO5
When credits are available, I can build the schematic and PCB from this plan.
Use GPIO4/GPIO5
Check safe GPIOs
Specify JST-XH wiring
Document requirements
Sign up to send

To get started, talk to Flux or create a New Document.

Documents

    Documents are markdown text files which describe project goals, capture details, or even simulation outputs.

    Assets

    No assets added.

    Hilarious Rose Flying Cab

    Hilarious Rose Flying Cab thumbnail
    Welcome to your new project. Imagine what you can build here.

    Properties

    Properties describe core aspects of the project.

    Pricing & Availability

    See prices from popular manufacturers for your project.

    Controls