Raspberry Pi Aquarium HAT
Thought for 4 mins 37 sec
1/4 Inspect current PCB outline, placement, routing, pours, airwires, and DRC
Inspect current PCB outline, placement, routing, pours, airwires, and DRC
Correct placement and board constraints against the final specification
Complete top-layer routing and bottom GND plane
Run final DRC/connectivity verification and remediate remaining violations
Thought for 4 sec
Referenced guidance.
Thought for 8 sec
Searching executors in /daveww00/raspberry-pi-aquarium-controller-hat~c8…
Thought for 6 sec
Reading Aquarium HAT PCB Layout's report…
Thought for 14 sec — Calculating footprint adjustments
Steering Aquarium HAT PCB Layout…
Thought for 7 sec
Awaiting 1 background task
Received notification from "Aquarium HAT PCB Layout" that it finished — picking the work back up.
Thought for 7 sec
I reviewed the prior layout report and resumed the PCB build with a defined connector-placement compromise: J2 remains flush right, while J14 is positioned as close as safely possible because both connector footprints cannot fit flush along the 65 mm edge.
The layout task completed, but I could not retrieve its final report or independently confirm routing, bottom GND fill, zero airwires, or DRC status.
Remaining
- Inspect the applied PCB changes.
- Verify the 85 × 65 mm outline and J1 anchor.
- Confirm 2.0 mm 5 V and 1.5 mm LED routing widths.
- Run final airwire, connectivity, and DRC checks.
- Fix any remaining routing violations.
Execution stopped because your ACUs ran out.
Inspect completed layout
Check routing completion
Verify critical widths
Review connector compromise
Inspect ground plane
