Importing SparkFun Schematic
Thought
flux
I’ll match the SparkFun MAX-M10S breakout’s board size and overall placement: first source the official board dimensions, then resize, place the edge connectors/mounting features, arrange the GNSS/RF and support blocks, and verify overlaps/board-edge issues.
Worked
flux
Resized the PCB to the SparkFun reference dimensions—38.1 × 30.48 mm (1.5 × 1.2 in)—and re-placed all 34 PCB footprints in a similar compact arrangement.
- U1 centered
- SMA connector on the right edge
- Signal header on the left
- Serial header along the bottom
- Qwiic connectors on the top/bottom-left
- Backup battery upper-left
- ANT1 upper-right
- RF components clustered near U1’s RF input
- Small passives moved to the bottom where necessary
- ✅ No component overlaps or pads outside the board
Open items:
- The layout is dense because ANT1 and several additional parts are not present on the original SparkFun board.
- J5’s body intentionally overhangs the left edge slightly.
- The four SparkFun-style mounting holes have not been added.
Suggested next steps:
- Add four 3.3 mm mounting holes at the SparkFun locations.
- Add ANT1’s copper/component keepout.
- Route the RF path first, followed by power and digital signals.
Add holes and keepout
Add mounting holes
Add antenna keepout
Review placement image
Check layout issues
