AA Torch Design

Thought for 2 mins 43 sec
Thought for 8 sec — Considering layout execution
Referenced guidance.
1/4 Inspect current PCB state and component footprints
Accessed knowledge for the next task.
Thought for 8 sec
Getting a layout overview.
Thought for 12 sec — Assessing sizing and dimensions
2/4 Create a compact handheld-torch board outline

Inspect current PCB state and component footprints

Create a compact handheld-torch board outline

Place components for access and short LED current path

Verify bounds, overlaps, and placement DRC

Accessed knowledge for the next task.
Thought for 13 sec
Thought for 9 sec
Awaiting 1 background task
Received notification from "PCB Placement" that it finished — picking the work back up.

flux

The compact placement is complete. I’m reconciling the final coordinates and independently checking the 20×40 mm outline, component access, and placement DRC.

flux

Created a compact 20 × 40 mm, 2-layer PCB and placed all components on top:
  • LED centered at the front edge
  • Battery connector centered at the rear
  • Slide switch accessible along the side
  • Resistor positioned beside the LED
Placement verification found no overlaps, out-of-bounds parts, or keepout violations. Three expected airwires remain because routing was not requested.
Suggested next steps
  1. Route the three connections.
  2. Add a ground copper fill.
  3. Clean up silkscreen labels and run final DRC.
Route and finalize
Clean silkscreen
Check enclosure fit
Prepare manufacturing files
Sign up to send

Files

Schematic

Layout

Preview

J1
SW1
D1
R1
Resistance
82Ω
No files yet