Part Information Review and Update
Thought for 7 mins 3 sec
I reviewed the part project and updated the missing
Summary
Current part info
Datasheet URL to the official Amphenol PDF: https://cdn.amphenol-cs.com/media/wysiwyg/files/drawing/10154206.pdf. That matches the recommended part-project verification flow: first ensure the datasheet URL exists, then compare project metadata, terminals, and footprint against the datasheet/source dataTable
| Field | Current value | Review |
|---|---|---|
| MPN | 10154206-04021LF | Looks correct |
| Manufacturer | Amphenol ICC (FCI) | Looks correct |
| Part Type | Connector | Looks correct |
| Designator Prefix | J | Correct for a connector |
| Package or Case Code | R0402 | Likely incorrect / misleading |
| Description | Connector Header Surface Mount, Right Angle 4 position 0.031" (0.80mm) | Good, aligns well |
From the official product listing for 10154206-04021LF:
Table
| Spec | Value |
|---|---|
| Series | FitMate 0.80 mm Wire-to-Board |
| Positions | 4 |
| Rows | 1 |
| Pitch | 0.80 mm |
| Style | Header |
| Orientation | Right angle |
| Mounting | SMT |
| Contact plating | Gold flash |
| Current rating | 0.5 A |
| Operating temperature | -25 °C to +85 °C |
| Housing material | LCP |
| Contact material | Copper alloy |
- There are 4 terminals in the symbol.
- Terminal designators are
1,2,3,4. - Pin numbers are
1,2,3,4. - All are marked
Passive. - I found no pin descriptions populated.
- The footprint contains 4 numbered pads:
1to4. - It also contains 2 extra mount pads:
SH1andSH2.
Table
| Area | Result | Notes |
|---|---|---|
| Pin count | Match | 4 signal pins in symbol and 4 numbered footprint pads |
| Pin numbering | Match | 1-4 on symbol and footprint |
| Pin type | Reasonable | Passive is appropriate for connector contacts |
| Pin descriptions | Incomplete | No pin descriptions are currently set |
| Footprint extra pads | Needs confirmation | SH1 and SH2 appear to be mechanical / hold-down pads |
| Package property | Mismatch flagged | R0402 does not look like a valid connector package code for this part |
- Datasheet URL was missing and is now set.
Package or Case Code = R0402is likely wrong. That looks like a passive package code, not a 4-position right-angle SMT connector package.- Pin descriptions are missing. If the datasheet only numbers the contacts without distinct signal names, this is not an electrical mismatch, but the metadata is incomplete.
- Footprint has
SH1/SH2pads not represented in the symbol. That may be perfectly fine if they are non-electrical hold-down tabs. Per the sync guidance, numbered electrical pins must match exactly, while extra non-electrical mounting features should be reviewed rather than blindly treated as errors
- Update
Package or Case Codeto a connector-appropriate package identifier from the manufacturer drawing. - Add pin descriptions if the datasheet gives any meaningful contact naming.
- Confirm whether
SH1andSH2are mechanical tabs only. If yes, leaving them out of the symbol is acceptable.
If you want, I can do the next pass and update the incorrect package property and add pin descriptions where the datasheet supports them.
Fix metadata issues
Check mounting tabs
Review connector footprint
Thought for 1 sec
- Set Datasheet URL to "https://cdn.amphenol-cs.com/media/wysiwyg/files/drawing/10154206.pdf"
