Wireless Stick Lite V3 Pin Functionality
Thought
Work done
- Ensured the two 1x20 headers are present as J2 and J3
- Added 40 breakout terminals and named them per your mapping:
- Wired every terminal to its corresponding header pin, and tied both GND pins into the schematic ground portal net (via GND)
Success criteria review
- ✅ J2 and J3 present
- ✅ 40 correctly-labeled terminals added (20 for J2, 20 for J3)
- ✅ Each terminal connected to the correct pin number on J2 / J3, with GND using the ground portal
- ✅ ERC checks for single-pin nets and undriven nets are clean
Next steps
If you want, I can also classify nets (Power/Ground/Signal) and then we can move on to PCB layout prep (stackup/rules).
organise correctement le terminals pour respecter l'epacement de 2.54 mm
Thought for 2 mins 2 sec
D’après la documentation Flux, le schéma ne permet pas d’imposer un pas de 2,54 mm:
“Flux’s schematic editor doesn’t use a traditional grid. Instead, components snap relative to each other for faster, cleaner placement. Just drag a component near another and alignment guides will appear—helping you line things up visually without worrying about grid spacing.”
Source
Si tu veux quand même les aligner proprement, utilise l’alignement visuel et les guides lors du déplacement.
Aligner avec raccourcis
Espacement des terminaux J2/J3
Organisation en colonnes
Aligner sans grille
Raccourcis d’arrangement