Cyberdeck Schematic Review
Thought for 5 sec
I see the uploaded schematic JSON for the Cyberdeck project. What would you like me to do with it — review it for issues, import/rebuild it into this Flux project, compare it against the current schematic, or use it as a reference for layout?
Review uploaded schematic
Compare current project
Rebuild from JSON
Check beginner issues
Explain next steps
Refine this doc
Ask about this doc
Project Specification
Purpose
Cyberdeck power hub PCB for distributing a boosted Li-ion battery rail to an Arduino VIN header, servo power header, voltmeter terminal, and button signal header.
Board Constraints
- Board size: 50 mm x 70 mm
- Stackup: Standard 2 Layer
- Top-level assembly uses external modules for charging and boost conversion.
Main Blocks
- TP4056 Type-C Li-ion charger module: battery input and protected output terminals.
- MT3608 boost converter module: boosts the charger output to the system distribution rail.
- Rocker switch terminal: switches the boosted output rail before feeding loads.
- External connectors: battery, voltmeter, servo, Arduino VIN/GND, and button signal/GND.
Required Connections
- BATTERY B+ to TP4056 BAT+
- BATTERY B- to TP4056 BAT-
- TP4056 OUT+ to MT3608 VIN+
- TP4056 OUT- to MT3608 VIN- and GND rail
- MT3608 VOUT+ to rocker switch pin 1 and voltmeter pin 1
- Rocker switch pin 2 to Arduino VIN and Servo VCC
- GND rail to Arduino GND, Servo GND, Button GND, and Voltmeter pin 2
- Button SIG net is labeled ARDUINO_D4 for external Arduino Pin 4 wiring
Notes
The charger and boost converter are represented as modules; their onboard passives and IC-level recommended circuits are assumed to be present on the modules. Final routing should use appropriately wide traces for battery, boost input, boost output, and switched output current paths.
Purpose
Board Constraints
Main Blocks
Required Connections
Notes
