Rev B POC Module Design
Add the remaining power-entry protection, replace the connector/jumper placeholders, update docs, and rerun ERC.
Thought for 10 sec
I’ll add the remaining input/output protection parts, replace the backplane and CAN termination placeholders with closer exact parts if available, update the power/CAN docs, then rerun ERC.
Thought for 20 sec
I’m blocked because the account has no available ACUs, so I can’t continue editing the schematic or running ERC right now.
Accomplished in this session:
- Acknowledged the requested scope.
- Set up the work plan for:
- finding replacement parts for
J_BP1andJ_CAN_TERM, - adding power-entry protection,
- wiring the protected rails,
- updating docs,
- rerunning ERC.
- finding replacement parts for
Remaining work:
- Replace
J_BP1with the exact Phoenix MC 1,5/10 3.81 mm backplane connector or best verified equivalent. - Replace
J_CAN_TERMwith an exact 2-pin jumper/header. - Add and wire remaining power-entry protection:
- reverse-polarity protection,
- PTC/fuse on
+24V_LOGIC, - input TVS,
- output-bank fuse on
+24V_OUT_EN, - any required bulk/input capacitors.
- Update the CAN/power sheet documentation and locked BOM notes.
- Rerun ERC and resolve any actionable warnings/errors once ACUs are available.
Check ACU options
List protection parts
Show protection wiring
Draft documentation
Manual update package
