PCB Relay Sketch Layout
0:39
Below is a summary of your PCB sketch in a structured format, including the relay footprint, associated connections, and Fmb module placement:
Relay Footprint (5-Pin SPDT Relay)
| Pin | Label | Connection Description |
|---|---|---|
| 85 | Live | Connect to the power source (e.g., +12V or VCC line). Trace from a VCC input pad (through-hole or SMD) to pin 85. |
| 86 | Dout | Connect to the external control output. Trace from an external pad labeled "Dout" directly to pin 86. |
| 87 | Switch | Connect to the main switch output. Route trace from pin 87 to an external pad labeled "Switch". |
| 87a | Switch + Ignition | Connect to the Switch + Ignition line. Route trace from pin 87a to a pad labeled "Switch+Ignition". |
| 30 | Output (Din) | Functions as the Din input as well as an output. Route trace from a pad labeled "Din" to pin 30, then extend the trace further to an output pad labeled "Output". |
Fmb Module (3-Pin Header or Block)
| Pin | Label | Connection Description |
|---|---|---|
| VCC | VCC | Connect the Fmb VCC pin to the same VCC used by relay pin 85 (power source). |
| GND | GND | Connect the Fmb GND pin to a ground plane or GND trace. |
| Din | Din | Connect the Fmb Din pin to relay pin 30 (shared Din line). |
PCB Layout Considerations
-
Power Planes:
- Use a thick trace or dedicated VCC plane for the Live connection (relay pin 85) and Fmb VCC.
- Use a solid GND plane or wide trace for Fmb GND.
-
Signal Traces:
- Use thin traces for signal connections (Dout from relay pin 86 and Din from relay pin 30) to clearly differentiate from power lines.
-
Component Placement:
- Place the relay centrally.
- Position the Fmb module near the relay (e.g., to the left).
- Arrange external pads (Switch, Switch+Ignition, Output) such that traces for pins 87, 87a, and 30 can branch out clearly.
-
Pad Labeling:
- Clearly label each pad (e.g., "Live", "Dout", "Switch", "Switch+Ignition", "Din/Output") for easy identification during layout review.
-
Grey - None:
- Any pad or reference marked as "Grey" should remain unconnected or be noted as NC (not connected).
Would you like to translate these descriptions into schematic suggestions (adding components and wiring) within your Flux project, or do you need further details on any aspect of the layout?
Schematic conversion
Place relay and Fmb in schematic
Add components to schematic
388 days
To get started, talk to Flux or create a New Document.
Welcome 👋
Flux helps you build PCBs faster with an AI teammate!
Create your account to collaborate, stay updated, fork your own version, and get instant answers from our AI agent.