PCB Design for EtherCON Connections
Thought for 4 sec
I’ll enlarge the PCB solder pads while keeping the existing schematic intact, then verify the layout for obvious clearance issues.
Worked for 2 mins
Done — I enlarged the four 3-pin solder groups (J3–J6) from 1.95 mm pads to 2.3 mm pads and added 0.1 mm solder-mask expansion for easier soldering.
I also changed those pads to thermal relief connections to make hand-soldering easier. Layout review still shows pre-existing routing/overlap issues, so the board likely needs routing cleanup or more spacing before manufacturing.
how much money have I spent in tokens so far?
Thought for 3 sec
I don’t have access to your token usage, billing records, or dollar spend for this chat/project.
You can check usage and billing in your Flux account billing/usage area. If you need help from Flux support, use: https://docs.flux.ai/Introduction/getting-support
Fix layout issues
Run full review
Increase board spacing
Check manufacturability
Export gerbers
