Minimal Setup for Pi Pico 2

A

amirkat

Add the minimum required components needed for this Pi Pico 2 to function properly. Keep the design as simple and minimal as possible.
You may include a single humidity sensor as the primary peripheral, along with any essential supporting components such as power regulation, pull-up resistors, decoupling capacitors, or required connectors.

flux

I’ll keep this minimal: inspect the Pico 2 shield pins, choose a simple 3.3 V I2C humidity sensor, add only required pull-ups/decoupling, wire it to the Pico header, then run checks and document the pin mapping.

flux

Processing was stopped.
Use I2C sensor
Minimal USB power
Add programming access
Run ERC check
Sign up to send

Files

Schematic

Layout

3D View

U1
No files yet