USB-C Sensor Node
Thought for 5 sec
I can’t execute the design right now because this account has no available ACUs, so AI project-editing features are unavailable.
Current project state:
- New empty project: “Registered Green Flubber”
- Components: 0
- Nets: 0
- No schematic, PCB, BOM, or documentation has been created yet.
What remains to be done once ACUs are available:
- Create a project specification for the USB-C powered Wi-Fi/BLE temperature and humidity sensor node.
- Select the MCU/module, likely an ESP32-class Wi-Fi + BLE 5.x module or another ultra-low-power dual-radio SoC/module.
- Select a digital temperature/RH sensor, USB-C receptacle, protection ICs, regulator/power-path parts, and passives.
- Build the schematic with USB-C 5 V default sink behavior, reverse/OVP/UVLO/OCP protection, 0.5–3 A input planning, 3.3 V regulation, MCU, sensor, programming/debug, and RF keepouts.
- Run power-budget and electrical checks.
- Create layout with antenna clearance, USB-C placement, protection close to connector, and consumer-product manufacturability constraints.
- Add bring-up, firmware pin map, and regulatory/compliance documentation for the wireless consumer device.
Save requirements note
Choose key parts
Draft architecture
Calculate power budget
No schematic yet
Talk to Flux to get started.
