Part Review and Datasheet Update
Worked for 6 mins 46 sec
Reviewed the NPM1100-QDAA-R7 part metadata, symbol pins, and footprint against Nordic’s nPM1100 documentation. I recorded the official Nordic datasheet URL in project metadata and created the detailed review here:
part-review-npm1100-qdaa-r7.Open items / mismatches:
- Pin 3 is labeled
VOUTBSET2; latest Nordic docs say it should beVOUTBSET0. - Pin 4 is labeled
NC_1; latest Nordic docs say it should beAVSSground. - Exposed pad is labeled
GND; datasheet names itAVSS— electrically OK, but naming should be clarified. - Pin types/descriptions are mostly unspecified and should be populated from the datasheet.
Suggested next steps:
- Rename/fix the mismatched terminals.
- Populate pin descriptions and pin types from the datasheet.
- Re-check the footprint pad geometry against the QFN-24 4×4 mm exposed-pad land pattern.
Thought for 6 sec
I’ll correct the mismatched NPM1100-QDAA-R7 pins, populate pin descriptions/types from the Nordic QFN24 pin table, then run a fresh schematic/footprint review.
Thought for 39 sec
I found the three symbol naming mismatches still present: pin 3, pin 4, and the exposed pad label. I’m applying the corrected Nordic QFN24 names and descriptions now.
Worked for 2 mins 20 sec
Updated the symbol/footprint pin labels and metadata:
VOUTBSET2 → VOUTBSET0, NC_1 → AVSS, and exposed pad GND → AVSS_EP. I populated all 25 terminals with datasheet-based pin descriptions and Flux-valid pin types, then reviewed the symbol/footprint checks; no open warnings/errors were reported.Open items:
- The exposed pad is named
AVSS_EPto avoid duplicateAVSSlabels while preserving datasheet meaning. - Pad geometry dimensions were not exposed in the review output, so only pad naming/count consistency was verified.
Suggested next steps:
- If desired, import/check the exact Nordic QFN-24 4×4 mm land pattern dimensions.
- Publish the corrected part revision.
Check land pattern and publish
Check land pattern
Run full review
Publish revision
Update review document
