Part Review and Datasheet Update
Thought for 8 sec
Understood. Once ACUs are available, I’ll update the MC7805CTG pin types/descriptions and verify that the TO-220 tab/thermal pad mapping is correctly tied to ground per the datasheet.
Pending checks:
- Pin 1: Input — power input
- Pin 2 / tab: Ground — regulator ground and heatsink tab
- Pin 3: Output — regulated +5 V output
- Footprint: confirm center lead and exposed/tab copper both map to GND where applicable.
Update the pin types and descriptions now using the MC7805CTG datasheet.
Thought for 4 sec
I’ll update the MC7805CTG terminal types/descriptions from the onsemi datasheet, then inspect the result to confirm the pin metadata is correct.
Worked for 46 sec
Updated and verified the MC7805CTG terminal metadata from the onsemi MC7800 datasheet.
- Pin 1 / INPUT:
Power In, “Voltage Input” - Pin 2 / GROUND:
Ground, “Ground / Tab” - Pin 3 / OUTPUT:
Power Out, “Regulated 5 V Output”
The schematic now matches the datasheet pin functions.
Verify footprint and run checks
Verify tab mapping
Check TO-220 footprint
Run ERC and DRC
Update review report
