To connect pin 2, which corresponds to the UV (Undervoltage) input of the LTC4365ITS8#TRMPBF IC, to VOUT (pin 7), you typically use a voltage divider to set the undervoltage threshold. This will ensure the IC disconnects the load if the input voltage falls below a specified level.
Here’s a basic way to do it:
Voltage Divider Setup: Connect two resistors in series between VIN (pin 1) and GND (pin 4).
The junction between these two resistors is connected to the UV (pin 2).
Connecting VOUT:
Connect VOUT directly to the load you wish to power.
Ensure VOUT is properly connected as specified in your design.
Here's a suggested connection format:
Connect UV to a voltage divider node.
Connect VOUT to the load.
Please confirm if you're planning to use a specific undervoltage threshold, so I can suggest resistor values for the voltage divider, or let me know if you have any other requirements for this project!
avtoo
copilot