I’ll review the part metadata, find and attach the official datasheet if needed, then compare the symbol/footprint/pin descriptions against it and report any mismatches.

Completed the review and attached the official Renesas DG401/DG403 datasheet URL to the part project. I found a major issue: the current symbol/footprint pin mapping does not match the Renesas DG403DYZ datasheet — only VL on pin 12 matches; 15 of 16 pins are mismatched.

Full findings, key specs, and the pin-by-pin mismatch table are saved in DG403DYZ-ND Part Review (dg403dyz-nd-part-review). Recommended next step is to correct the symbol pin names/numbers and change Manufacturer Part Number from Digi-Key DG403DYZ-ND to manufacturer MPN DG403DYZ.

I’ll update the terminal names and Pin Number properties to match the Renesas DG403DYZ 16-pin datasheet pinout, then re-read the symbol to verify the mapping.

Updated the DG403DYZ symbol terminals to match the Renesas datasheet pinout: pin 1 IN1, 2 D1, 3 S1, 4 V-, 5 GND, 6 S4, 7 D4, 8 IN4, 9 IN3, 10 D3, 11 S3, 12 VL, 13 V+, 14 S2, 15 D2, 16 IN2.

I verified the schematic now has all 16 expected terminal names and pin numbers. Note: one terminal (D4) had to be replaced rather than renamed because the duplicate NC label would not target reliably by UID; its Pin Number and symbol pin position were restored.