ADS1115 Product Info


image

I see the image shows an ADS1115 module/product description: 16-bit ADC, I2C interface, 4 single-ended or 2 differential inputs, programmable gain, and 2.0–5.5 V supply range.
What would you like me to do with it — verify compatibility, wire it into your WellCore project, compare it to the current ADS1115 eval board, or prepare a purchase/connector note?
This the ADS I use the PCD Rev A had wrong ADS
Understood — this is the ADS1115 module you actually use, and PCB Rev A had the wrong ADS/ADC part or footprint.
For Rev B, the important correction is to design around the exact ADS1115 breakout/module interface, not just the ADS1115 IC. That means verifying:
  • module pin count and pitch
  • pin order: VDD, GND, SCL, SDA, ADDR, ALRT, A0–A3
  • supply voltage used by your controller
  • I2C pull-ups: whether they are already on the module or need to be on the carrier PCB
  • mechanical fit and connector/header orientation
Because this project is owned by adrian95 and you only have comment access here, I can’t directly edit this PCB. The safest next step is to apply the ADS correction in your editable project, likely donny1787/wellcore-project, and replace the wrong Rev A ADS interface with the verified ADS1115 module/header pinout.
Fix ADS interface
Verify pinout first
Check pull-ups
Create Rev B notes
Review editable project

Pin #
Name
Type
Section
Pin Group
Orientation
Order
Sub-symbol
JP1_1
A+
Input
JP1_2
A3
Input
JP1_3
A2
Input
JP1_4
A1
Input
JP1_5
A0
Input
JP1_6
A-
Input
JP2_1
VIN
Power In
JP2_2
GND
Power In
JP2_3
SCL
Input
JP2_4
SDA
Bi-Directional
JP2_5
ADDR
Input
JP2_6
ALRT
Output
SH1
SHIELD
Passive
SH2
SHIELD
Passive
SH3
SHIELD
Passive
SH4
SHIELD
Passive

1085