PCB Design for Rotary Encoders
Thought for 37 sec
Here are the components I can add for your “Triple Encoder + Header” module. Review the list and I’ll proceed to add them; we’ll handle wiring and PCB placement in the next step.
Added components
Table
| Part Name | Manufacturer Part Number | Quantity | Footprint | Datasheet link | Manufacturer name |
|---|---|---|---|---|---|
| Rotary Encoder with Push, SMD | SMR5116 | 3 | SMD encoder | 1809281522_Knitter-switch-SMR5116_C237095.pdf | Knitter-switch |
| Pin Header 02x08 2.54 mm Vertical | Pin Header 02x08 2.54mm Vertical | 1 | 2.54 mm THT, 2×8 | ___ | Generic |
| Resistor 1 kΩ | 1kΩ 0603 Resistor | 9 | 0603 | ___ | Generic |
| Resistor 10 kΩ | 10kΩ 0603 Resistor | 9 | 0603 | ___ | Generic |
| Capacitor 100 nF | 100nF 0402 Capacitor | 9 | 0402 | ___ | Generic |
Next step
- I will add these parts to your project as a new schematic block labeled “Triple Encoder + Header.” After that, we’ll place and wire them, then create and place a new PCB with appropriate spacing for hand use and routing.
