Temperature and Humidity Sensor Node Design


Placed 27 component(s): R10, C7, C8, R5, SW1, U4, R6, R2, U1, R7, C1, C2, R1, SW2, C4, R3, C3, U3, U2, D1, R4, J2, R9, J1, C6, C5, R8
Placed 5 component(s): C7, R5, SW1, U3, J2
Work done
  • Built the USB-C powered ESP32-C3 temperature/RH sensor node schematic with USB-C CC pull-downs, TPS259530 protection, TLV75533 3.3 V regulation, SHTC3 I2C sensor, decoupling, reset/boot circuitry, UART header, and GPIO2 boot strap pull-up.
  • Cleaned ERC warnings by wiring R10 and marking unused ESP32-C3 GPIOs intentional no-connects.
  • Set the PCB to a 50 mm × 50 mm rounded 4-layer board and placed all components with USB-C at the edge, ESP32 antenna at the top edge, sensor away from heat, and header accessible on the right.
  • Updated Design Notes and created Firmware Starter — ESP32-C3-MINI-1-N4.
Success criteria review
  • ✅ Required schematic components and power protection are present.
  • ✅ Electrical support parts are included: CC resistors, I2C pull-ups, 100 nF decoupling, EN RC reset, BOOT controls, and programming header.
  • ✅ ERC is clean for the checked schematic issues; footprints, invalid layers, and overlapping copper checks pass.
  • ✅ Preliminary PCB layout planning is complete with board outline, stackup, and RF-aware placement.
  • ⚠️ Routing is not complete yet: the board still has 43 airwire reports because traces have not been routed.
Next steps
  • Route the PCB next, then re-run DRC/airwire checks and prepare manufacturing exports if desired.
Route remaining airwires
Full design review
Prepare manufacturing exports
Verify antenna keepout

Schematic of USB-C ESP32 Environmental Sensor
J1
J1 SHIELD - U1 GND
U3 GND - U3 GND

USB-C ESP32 Environmental Sensor

USB-C ESP32 Environmental Sensor thumbnail