RST Pin Functionality Overview

S

sgoettl17

@web find the datasheet for the RST and then list and describe each of its pins.
Include their function, input/output characteristics, and any special considerations for proper usage.

flux

You’re pointing at RST, which is a Net Portal (a named net), not a device with its own datasheet. In this project, RST ties to the ESP32 module’s enable/reset pin: U1 EN (a.k.a. CHIP_EN). Below are the EN/CHIP_EN pin details taken from the module datasheet.
Source: ESP32-H2-WROOM-03 Datasheet (Espressif) – Datasheet
EN / CHIP_EN (ESP32-H2-WROOM-03)
  • Function
    • High: chip enabled (powered up).
    • Low: chip disabled (powered down).
    • Do not leave floating.
  • Pin type and direction
    • Digital input (chip enable/reset).
  • Input characteristics (DC, 3.3 V, 25 C)
    • High-level input threshold (VIH): at least 0.75 * VDD1
    • Low-level input threshold (VIL): at most 0.25 * VDD1
    • Input leakage currents: IIH <= 50 nA, IIL <= 50 nA
    • Default biasing: internally pulled up
  • Recommended external network (from module datasheet)
    • 10 kΩ pull-up to VDD33
    • 1 µF capacitor from EN to GND
  • Special considerations
    • Keep EN’s RC network close to U1 to reduce noise coupling.
    • Since EN controls full chip power-down, avoid long/noisy traces and ensure a solid pull-up so it cannot float.
    • For reliable power-on reset behavior, follow the 10 kΩ + 1 µF recommendation above.
    • General MCU reset best practice: include a pull-up on reset/enable lines; diagnose EMI or supply sags if you observe spurious resets.
If you’d like, I can add the recommended 10 kΩ pull-up and 1 µF capacitor to EN on U1.
Add EN reset network
Confirm RST net connections
Add reset button
Check EN thresholds
Add programming header
Sign up to send

Files

Schematic

Layout

3D View

Schematic of ESP32-H2 Relay Board
PS2
U1

ESP32-H2 Relay Board