Dual ESP Carrier Fit


Updated the requirements, board markings, and documentation to 1 A per output, 4 A per bank, and 8 A total load; I also widened one output’s narrow copper connection. Fresh checks still show zero missing connections, copper shorts, or redundant traces.
The lower current reduces heating, but doesn’t clear fabrication yet: one via defect remains, and supply/return capacity plus mounting clearance still need verification. Details are in the Revised Current-Path Review; 1 A is the intended load ceiling, not an automatic hardware current limit.
What do I need to do now
Don’t order the PCB yet. You don’t need to move anything else. The next step is to have a Flux engineer help resolve the remaining via/tool blocker and review the power paths for 1 A per output, along with mounting-screw clearance.
I’ve tried several repairs, but I haven’t established fabrication readiness. A free engineering review is the most useful next step; for the protected-copper tool issue, use Flux support. After those blockers are resolved, I can verify and generate the manufacturing files.
I give you free rein to move things where they need to be to make this work.
You’ve already given me that permission, and I used it in the latest repair attempts—the blocker is not your placement restrictions. The remaining via repair and power-path verification need engineering/tool support; moving more parts without a verified solution could undo working connections, so I’m holding fabrication until those issues are resolved.
Ok
The board remains on hold for fabrication. Use the engineering-review card above or Flux support, and share the project link plus the Revised Current-Path Review so they can see the remaining blockers.

ESP32 Socket Pin Map
Physical orientation
Applies identically to MCU A (J1/J2) and MCU B (J21/J22). View the removable board from the component side with the antenna at the top and both USB-C connectors at the bottom. On each socket row, pin 01 is the physical top contact and numbering increases top-to-bottom. Pitch is 2.54 mm, 22 contacts per row, and the user-verified row separation is 25.4 mm.
Left row: J1 / J21

Table


SocketBoard signalAssigned carrier function
013V3local 3V3
023V3local 3V3
03RSTreserved
04–07GPIO4–7LED data 1–4
08GPIO15trigger 4
09GPIO16CAN TX
10GPIO17CAN RX
11GPIO18CAN standby
12GPIO8high-side command 1
13GPIO3reserved boot strap
14GPIO46reserved boot strap
15–17GPIO9–11high-side commands 2–4
18–20GPIO12–14triggers 1–3
215VINmanual-link dev-board 5 V feed
22GNDground
Right row: J2 / J22

Table


SocketBoard signalAssigned carrier function
01GNDground
02GPIO43free; preserve UART/debug access
03GPIO44free; preserve UART/debug access
04GPIO1free
05GPIO2free
06GPIO42I2C SDA
07GPIO41I2C SCL
08GPIO40protected spare terminal
09GPIO39protected spare terminal
10GPIO38free
11–13GPIO37–35reserved octal-memory pins
14GPIO0reserved boot strap
15GPIO45reserved boot strap
16GPIO48reserved onboard RGB
17GPIO47free
18GPIO21LED output enable
19GPIO20reserved native USB
20GPIO19reserved native USB
21–22GNDground
The seller graphic incorrectly places USB D+/D− descriptors beside GPIO21/GPIO20; canonical ESP32-S3 native USB GPIO19/GPIO20 takes precedence. Final production release still requires a continuity check from each socket contact to the actual removable-board label because this is seller evidence rather than a controlled manufacturer drawing.
  • Physical orientation

  • Left row: J1 / J21

  • Right row: J2 / J22