ESP32 Power Supply Schematic
Updated properties for 2 objects
0:04
Set C1's Capacitance to "100nF"
Set C1's Voltage Rating to "25"
Set C2's Capacitance to "100nF"
Set C2's Voltage Rating to "25"
Position C1 and C2 by VDD pins...
0:09
Started: Move C1 and C2 near the ESP32 VDD pins.
Thought
Work completed
- C1: set 100 nF, 25 V, 1206 footprint
- C2: set 100 nF, 25 V, 1206 footprint
- C3: set 10 µF, 16 V, 1206 footprint
- R1: set 10 kΩ, 1206 footprint
Remaining tasks
- Place C1 and C2 adjacent to the ESP32 VDD pins
- Place C3 next to the main VDD power input
- Place R1 near the ESP32 EN pin
- Verify all passives are using 1206 footprints and correctly aligned to their nets
Success criteria review
- ✅ All generic components were added with clear designators and correct values
- ❌ Footprint assignment and strategic placement have not yet been verified on the schematic
Recommended next step
Proceed to the Connectivity phase: move the passives to their target locations, connect them to the corresponding ESP32 nets, and then verify the 1206 footprints and placement before moving on to footprint review.
Welcome 👋
Flux accelerates your PCB design with AI.
Create your account to start using this component and bring your ideas to life.