Creating a non-rectangular PCB in Flux involves defining board outlines according to the shape you want. You can use the following steps:
Create a shape on the Edge.Cuts layer:
Flux allows you to draw lines on the "Edge.Cuts" layer which is used to define the outline of your board. You can use straight lines and arcs to create the shape of the board. Use commands like 'Line' and 'Arc' under the 'Draw' menu to create your outlines.
Connect the lines to form a closed shape:
Ensure that all your lines connect at the end points to form a complete outline. If your shape is not closed, Flux might not recognize it as a valid board shape.
Save and load your board:
Flux processes the shape on the Edge.Cuts layer as the shape of your board when you load it.
Place your components inside the board outline:
You will now see that your board has taken on the shape that you've outlined. Afterwards, you can place your components inside this shape in the schematic and layout editors.
Remember while creating a non-standard shape, consideration should be given to practical factors such as PCB manufacturing specifications and tolerances. Non-standard shapes might also increase the complexity and cost of manufacturing.
Note: Certain PCB fabrication facilities may have limitations on their ability to manufacture PCBs of irregular shapes. Always check with your PCB manufacturer's guidelines before sending your design for fabrication.
Yes, the VL6180XV0NR/1 from STMicroelectronics is marked as "Last Time Buy" or "End of Life" by multiple distributors. This usually means that the component is being phased out and will no longer be produced.
If you're looking for an alternative, consider the newer VL53L0X which offers better performance and similar functionality. However, ensure that the footprint and pin configuration match your requirements or be prepared for some redesign.
Would you like assistance with finding an alternative or redesigning your circuit?
atalhan
copilot
Flux allows you to draw lines on the "Edge.Cuts" layer which is used to define the outline of your board. You can use straight lines and arcs to create the shape of the board. Use commands like 'Line' and 'Arc' under the 'Draw' menu to create your outlines.
Ensure that all your lines connect at the end points to form a complete outline. If your shape is not closed, Flux might not recognize it as a valid board shape.
Flux processes the shape on the Edge.Cuts layer as the shape of your board when you load it.
You will now see that your board has taken on the shape that you've outlined. Afterwards, you can place your components inside this shape in the schematic and layout editors.