Child Safe RGB Badge


I’ll remove the per-LED WS2812B decoupling capacitors that were added despite the V6 datasheet feature note, then re-run checks and update the safety/power notes accordingly.
Removed C24–C43, the per-LED WS2812B-2020-V6 capacitors, and kept the shared LED-rail bulk capacitor C5. Re-ran checks: no open ERC/passive warnings found.
Updated:
J1 need PCB cutout, replace it with TYPE-C 16PIN 2MD(073)
I’ll replace J1 with the requested TYPE-C 16PIN 2MD(073), first finding the exact library part and preserving the existing USB-C nets, then I’ll verify the connector pins/checks afterward.
Replaced J1 with TYPE-C 16PIN 2MD(073) (LCSC C2765186) and restored the existing power-only USB-C wiring:
  • VBUS pins → VBUS_RAW
  • GND + shell pins → GND
  • CC1/CC2 → existing CC pulldown/ESD nets
  • DP/DN/SBU pins marked no-connect
Verified J1 schematic connectivity and ran targeted ERC/DRC checks; no J1-related open issues were reported.
Verify connector and layout
Place J1 at edge
Run full DRC
Verify cutout geometry
Update bring-up docs

Last modified 4mo ago

Preliminary Safety FMEA — USB-C RGB Toy Badge
Scope
Design-stage safety review for a child-worn rechargeable RGB badge. This is not a certification document and must be refined after layout, enclosure design, and prototype testing.
Failure Mode Table

Table


SubsystemFailure ModeEffectSeverityLikelihoodDetectionRPNMitigation
LiPo batteryWrong polarity pack connectedCharger/regulator damage, heating944144Freeze exact pack, verify JST polarity, add reverse protection before production.
LiPo batteryCell short or harness damageHeat/fire risk1035150Use protected pack, F3 near J2, strain relief, enclosed battery, no sharp board edges.
ChargerNo NTC/JEITACharging at unsafe battery temperature936162Prefer NTC-capable charger/power-path IC or NTC-protected pack; do not charge while worn.
Charger/load sharingBadge on while chargingCharge termination error or battery discharge while USB attached655150Add VBUS sense; firmware can reduce/disable LEDs; consider power-path charger.
LED railFirmware bug drives full brightnessHigh current, heat, uncomfortable brightness844128F2 LED PPTC, firmware current cap, thermal and optical validation.
3V3 railLED transient resets MCUErratic animations or stuck-on pattern554100Separate 3V3_LED branch, local LED decoupling, layout with solid ground.
USB-CHot-plug/ESD surgeCharger/MCU damage744112F1, D1, D2 added; still evaluate OVP/eFuse before production.
MechanicalBattery accessible or puncturedChemical/fire hazard1035150Enclosure, retention, strain relief, inaccessible without tool.
WearableLanyard/small parts hazardChild injury1036180Breakaway lanyard; no loose small parts; rounded corners.
Risk Priority Actions
  1. Define exact protected battery pack and mechanical retention.
  2. Decide whether to upgrade to NTC/power-path charger before layout.
  3. Add/validate reverse-polarity protection.
  4. Thermal-test LED animations and fault cases.
  5. Restart PCB placement with top LEDs only and bottom electronics.
  • Scope

  • Failure Mode Table

  • Risk Priority Actions