PCB Layout Conflict
Thought for 10 sec
I’ll open the attached text to see what you want done, then I’ll summarize or act based on its contents.
Worked for 4 mins 4 sec
Created a project doc
Pinch Breakout REV A1 — Project Specification
Breadboard adapter for the Moddo pinch connector/header pattern. The board adapts a central 2×8, 1.27 mm pitch male header to surrounding 2....
I created the project spec and renamed the project. Next I’m adding the through-hole headers and wiring the requested net map.
Worked for 7 mins 58 sec
I’m blocked by a mechanical conflict in the pasted placement map: the left-column bottom hole is D5 at X=0, Y=0, while the bottom-row left hole is RST at the same X=0, Y=0, so two different nets occupy the same drill hole.
Completed so far:
- Created the project spec: Pinch Breakout REV A1 — Project Specification
- Renamed/described the project.
- Added H1/J2/J3/J4 and wired the schematic netlist.
- Set the PCB to 18 × 15 mm, 2 layers, and started through-hole pad geometry.
To continue, I need one clarification: should the bottom row start at X=2.54 mm instead of X=0 so it does not overlap the left column, or is one of the listed corner nets incorrect?
Offset bottom row
Corner net correction
Fix overlap directly
Recheck after fix
Waiting for input
