IPEX Enclosure Design
Thought for 1 min 12 sec
The rebuilt base and lid are saved without perimeter ears, with four internal PCB mounts, cable exits, and separate reset-actuator and light-pipe models. Nominal geometry checks passed, but the render still shows the actuator and light pipe gray rather than black and transparent; I’m checking the saved assembly and documenting the remaining fit and molding limitations.
Thought for 4 mins 52 sec
Thought for 17 sec
2/2 Independently inspect saved geometry and report fit and molding limitations.
Rebuild and place curved enclosure with internal PCB mounts, cable exits, provisional snaps, black RST actuator, and clear LED1 light pipe.
Independently inspect saved geometry and report fit and molding limitations.
Thought for 25 sec
Awaiting 1 task
"Enclosure Review Findings" completed.
Worked for 4 mins 59 sec
I rebuilt and saved the curved enclosure—approximately 105 × 79 × 17.5 mm—without perimeter ears or exposed cover screws, retaining four internal PCB mounts and adding provisional snap retention, cable exits, a separate RST actuator, and an LED1 light pipe/aperture.
It remains provisional: the actuator and pipe still render gray rather than black/transparent; harness compatibility, reset tolerances, and molding qualification remain unresolved, as detailed in the project file Enclosure review results.
Next priorities are correcting the appearance/export issue (Contact Support) and verifying the harness drawing and production resin requirements.
Get Free Expert Help
We want to get the prototype into your hands fast. Speak with one of Flux's in-house electrical engineers to review your project.
Collins, Ryan, Nico — real humans who've shipped real hardware
Waiting for input
