Device Proximity Alert System


Yes
I’ll use the approved concept to build a first-pass enclosure and mounting bracket, then develop the prototype electronics around it. I’ll keep the battery and display fit provisional until actual parts are selected, and record anything that still needs physical testing.
Finished 2 executions
"Vehicle Proximity Alert Risk Review" completed.
"Vehicle Alert Enclosure Design" completed.
I recorded your concept approval and created a partial enclosure CAD assembly, provisionally 120 × 145 × 47.8 mm. Seven models are placed: the shell, front lid, board carrier, bracket, and board/display/battery placeholders; editable sources and handoff details are saved in the Mechanical Build Report.
It is not ready to print. Remaining work includes:
  • Repair the bracket mounting slots and check pivot clearance.
  • Place buttons and hardware, then verify assembly fit and screw paths.
  • Select actual display and battery parts; their current shapes are placeholders.
  • Build the electronics and firmware—there are still no electrical components or nets.
Execution stopped because your ACUs ran out.

Waiting for input


Schematic of Vehicle Proximity Alert
No schematic yet

Talk to Flux to get started.

Vehicle Proximity Alert