Project Startup Help
Thought
Built Prototype Revision A — Not Production Validated in the schematic.
What was accomplished:
- Created a provisional RTX1090R1 Flux component from the public datasheet.
- Built wired transmitter and receiver schematic blocks: RF, codec, XLR audio, USB-C charging, Li-ion power path, fuel gauge, 3.3 V rails, and ±5 V analog rails.
- Cleared floating-pin and single-pin-net ERC issues.
- Documented remaining power/ERC caveats and RF production dependencies.
Project files:
- Prototype Rev A Assumptions and Dependencies
- Prototype Rev A Verification Notes
- Technical Construction File
Open items:
- Remaining ERC findings are Missing Power warnings tied to provisional/generated rails and RTX module output pins; they are documented in the verification notes.
- PCB layout is not started yet.
- RF antenna layout is placeholder-only until RTX/RMED reference files are available.
Suggested next steps:
- Review the schematic and verification notes.
- Proceed to schematic cleanup/arrangement.
- Define board outline and stackup for the 25 mm-wide Rev A PCB.
- Start placement with RF/audio/power separation and antenna keepouts.
i accidentally clicked on the schematic and created a line or two. how to undo? I don't understand it at all
Thought for 10 sec
No problem — if you just drew an accidental schematic wire/line:
- Press Ctrl+Z / Cmd+Z once.
- If that doesn’t remove it, click the accidental line so it highlights, then press Delete / Backspace.
- If you’re unsure what you selected, use Esc first to exit the current drawing tool, then try selecting the line again.
If you want, I can also inspect the schematic and remove any accidental dangling wire(s) for you.
Inspect and clean schematic
Remove accidental lines
Restore recent commit
Show undo steps
Run ERC after cleanup
