Yes - but these new uploads did not come through in a usable way for analysis.
What happened
I tried to process the attached PCB photos as image attachments, but the image fetches for these HEIC-based preview URLs are returning 500 errors, so I can't reliably inspect them right now. That means I should not pretend I can reverse-engineer the board from these specific files yet. This is exactly the kind of attachment-processing failure that needs a re-upload in a more directly readable format
Best next step
Please re-upload the photos as:
JPG or PNG files directly
preferably straight top-down
one photo of each side
one photo with a ruler or caliper
a few close-ups of the dense component area
For PCB/image attachments, the right workflow is:
inspect the image
extract visible topology, markings, and geometry
then decide whether it is enough to recreate the board in Flux
If you want the fastest accurate replication
Best-to-worst input quality:
Table
Input you send
Reconstruction quality
Gerber ZIP + drill files
Best
Original KiCad/Altium/Eagle files
Best
Flatbed scans of both PCB sides
Very high
Straight JPG/PNG photos of both sides
Medium
Angled phone photos only
Limited
What I can do once you re-upload
estimate the board outline
identify component placement
trace visible copper/routing
list what is recoverable vs still unknown
then help you recreate it in a new Flux project
If you want, send just 2 files next:
front side as JPG/PNG
back side as JPG/PNG
and I’ll assess whether the board is reconstructable from photos alone.